Hammond Skx PRO, Reference Manual, Page: 113 / 754

93
Combinations
t
Selecting a Combination
TRY THIS:
1. Turn the power to the SKX PRO “ON.” After the instrument finishes “booting” (approximately
40 seconds), the Information Center Display will look like this:
This is PLAY Mode, which is the normal performance mode. The following paragraphs explain each
line of the display.
The top line shows which Combination is currently active.
The line just below the top line shows which Parts are active, as well as Octave, Velocity and Volume
settings for the currently selected Part(s).
NOTE: The ORGAN Voice Section does not receive Velocity; therefore, the Velocity box on the line just
below the top line will not be shown.
The middle portion of the display shows which Patches are enabled within the current Combination.
A Combination will have Voices and Settings for each of the Voice Sections, but not all Combinations
will have all of the Voice Sections sounding. The ALLOCATE buttons will be “ON” or “OFF”
depending on which Patches are activated for the currently selected Combination.
NOTE: Selecting and de-selecting Patches will be covered later in this chapter.
HA<O>
SKX PRO Reference Guide