Halcro UTSR1, Owner'S Manual, Page: 12 / 44

Remote Control

Tap test keys on LCD screen or any of hard keys
to test the selected code

Tap to search next code, or command will be
sent at the same time

Tap to skip previous code

Tap Back to cancel and return to previous menu
page for selection of other brand name. (Follow
the above steps again)

Tap OK to confirm and exit the setup
Note: If you have reached the end of code, you will be
prompted to continue for Auto-Search or Exit. For
details of Auto-Search setup, please refer to Auto-
Search Setup section in this manual.
Enter Code
– setup pre-programmed code by
entering code number. (Halcro Logic UTSR1 is
preloaded with numerous control codes for most
popular AV equipment; you can refer to the enclosed
code list for your devices.)

Tap Enter Code from Setup menu

Select a device (e.g. TV)

Tap numeric digit to enter code number (check
your code from the code list, e.g. 0021)

Tap Delete to delete the last entered digit (if you
have mistyped a number)

Tap Back to cancel and return to previous menu
page

Tap OK to confirm the input

Tap Test Key on LCD screen or any of hard key to
test the corresponding function

Tap OK to confirm and exit the setup
Auto Search
- setup pre-programmed code by
searching through the library.

Turn on your device before starting this setup
procedure (e.g. TV)

Tap Auto Search from Setup menu

Select a device (e.g. TV)

Tap once and then repeat until your device is
switched off. Then, press OK to save the code. Or
you can tap the TEST key to test the device during
setup