Halcro UTSR1, Owner'S Manual, Page: 11 / 44

11
Dual Signal Learning – If you find that a Learn
command only works occasionally for your audiovisual
equipment, your original remote control may contain
dual signals. Please follow the below steps to
reprogram these commands.

Tap Learning from Setup menu

Select a device which you would like to carry the
command keys (e.g. TV)

Tap a key to be learnt from the Halcro Logic UTSR1

Aim the original remote to the front of the Halcro
Logic UTSR1. Press and hold the key until Halcro
Logic UTSR1 responds with a successful message
(approx. 5 seconds)

Edit the key name or just tap OK to confirm

Tap the same key on the Halcro Logic UTSR1

Again aim the original remote to the front of the
Halcro Logic UTSR1. Press and hold the same key
until Halcro Logic UTSR1 responds with a
successful message

Edit the key name or just tap OK to confirm
Note: The optimum receiving distance is 5 to 8cm for
remote learning. If you have any reported problem
during the learning process, adjust the distance and
try again.
Brand Name
– setup pre-programmed code by
selecting a brand name.

Turn on your device you wish to install before start
this setup procedure. (e.g. TV)

Tap Brand Name from Setup menu

Select a device (e.g. TV)

A brand name list in alphabetical order will be
displayed. Tap
or to browse the list, or tap a
character to access to a brand name. (e.g. ‘H’ for
Halcro)

Tap a brand name from the list, it will be highlighted
(e.g. Halcro)