HAKO 474, Instruction Manual

Page: 2 / 32

1
1. Packing List
Station .............................................................1
Desoldering Gun..............................................1
Iron Holder Base..............................................1
Spring Iron Holder ...........................................1
Cleaning Sponge .............................................1
Filter Pipe ........................................................1
Ceramic Paper Filter (S) ..................................2
Ceramic Paper Filter (L) ..................................4
Spring Filter .....................................................3
Cleaning Pin (for ø1.0mm [0.04 in] nozzle) ............1
Cleaning Pin (for Heating Element) .................1
Cleaning Pin Holder.........................................1
Cleaning Drill (for ø1.0mm [0.04 in] nozzle) ...........1
Silicone Grease ...............................................1
Wrench ............................................................1
Instruction Manual ...........................................1
Please check to make sure that all the items listed below are included in the
HAKKO 474 package.
Station Wrench
Iron Holder Base
Spring Iron Holder
Spring Filter Filter Pipe Ceramic Paper Filter (L)
Cleaning Pin Holder
Cleaning Pin
for ø1.0mm (0.04 in) Nozzle Cleaning Pin for Heating Element
Desoldering Gun
Cleaning Drill
for ø1.0mm (0.04 in) Nozzle
Silicone Grease
Cleaning Sponge
Ceramic Paper Filter (S)
2. Specifications
Name
Power consumption
HAKKO 474
100W
Part Name
Output
Vacuum generator
Vacuum pressure (max.)
Suction flow
Tip to ground potential
Tip to ground resistance
Outer dimension
Weight
24V ~
Vacuum pump, double cylinder type
80kpa (600 mm Hg) (24 in. Hg)
15
l
/min.
< 2mV (typical 0.6mV)
< 2
Ω
165(W)
×
135(H)
×
260(D)mm
(6.5
×
5.31
×
10.24 in.)
3.8kg (8.4lb.)
Part Name
Part No.
Power consumption
Temperature range
Insulation resistance
Nozzle inside diameter
Outer dimensions
Weight, less cord
HAKKO 809
C1183
24V – 50W
380 to 480°C (716 to 896°F)
> 300M
Ω
at 420°C (790°F)
ø1.0mm (0.04 in.) (nozzle S standard)
135(W)
×
174(H)mm (5.31
×
6.85 in.)
200g (0.44lb.)
l
Desoldering Gun
Condition of measurement
• Insulation resistance
The insulation resistance was measured between the nozzle and the lead of the heating element using a 500 V DC insulation resistance meter.
Caution: The insulation resistance cannot be measured between the nozzle and the power plug as the transformer between the secondary part
(heating element) and the primary part acts as an insulator.
• Voltage leakage
The voltage leakage was measured between the nozzle and the grounding plug at a temperature of 480°C (896°F) using an AC mV meter.
Caution: Be sure to ground the unit before measuring the voltage leakage.
• Specifications and design are subject to change without notice.
l
Station
English
NOTE:
* This product is protected against electrostatic discharge.
* Specifications and design are subject to change without notice.