Hakko Electronics Monitouch S8 Series, Hardware Specification

Page: 41 / 79

4-4 1. Coin-type Lithium Battery (S808C/S806C/S806M20)
6. Remove the battery from the socket.
Slide the battery from right to left and remove it from the socket.
7. Fit the new battery in the socket with its “+” side facing upward.
Slide the battery toward the direction of the arrow shown in the figure below and fit it in the socket.
8. Mount the rear case on the front case.
9. Tighten the four screws removed in step 4 at each corner on the rear case.
10. Entering an expiry date of the battery
Enter a date five years from now for on the caution sticker.
11. Turn the S8 unit on. Check that the message “Replace a battery after saving SRAM.” is not
displayed at the bottom center of the Main Menu screen.
12. If the backup data “
∗
.RAM” has been made, transfer it to the S8 series.
Socket
Battery
In the normal state:
When the battery voltage drops: