5
1. Remove the insulating cover from the handle cover
L-side as shown in figure 1 (side with HAKKO FT-
8004 logo) and remove the screw from the handle
cover L-side.
2. Remove the handle cover L.
3. Align the lead adjuster as shown in figure 3 in the
designated channel in the handle cover L. Tighten
lightly in place using mounting bracket and screw.
4. Firmly fit the bottom side of the insulation cover to
the handle cover as shown in figure 4.
5. Attach handle cover L to the handpiece at the bottom
and tighten the screw for handle cover L. Reattach
insulating cover to the top side of the handle cover
L. Adjust the length of the lead adjuster and firmly
tighten the screw.
― NOTE ―
Pay attention to the direction of the blades when
attaching the lead adjuster. (Refer to the following
figure.)
Attach the lead adjuster so that the adjuster plate end
is in parallel with the blade surface.
The lead adjuster can be removed with the handle
cover attached to the handle.
5-3 Handle
5-3-1 Attaching the lead adjuster
―
NOTE
―
The output value range is 5% to 100%. The output values can be set in increments of 5%.
If the output is 80% or less,
will be displayed when the handpiece is placed on the station indicating
the timer start for the auto sleep setting set by parameter 02. If
,
or [
ENTER
] are pressed while
is displayed, the current output value will then be displayed. If the output is more than 80%,
will be displayed when the handpiece is placed on the station, for more information refer to page 10.
Relation of display and blade temperature when handle is placed on the station
Output
Sleep function
Display
Blade temperature
80% or less
ON
→
: same as the output value
→
: 50% of the output value
OFF
Same as the output value
85% or more
ON
50% of the output value
OFF
50% of the output value
For setting parameters of the auto sleep function, refer to page 10.
Lead adjuster
Handle cover L
Insulating cover
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
