3
4.
INITIAL SETUP
1. Insert the blades fully and match the
V-groove on the blades to the V-groove
on the mounting flange. Push until blades
are flush with mounting flange.
2. Insert the hexagon socket set screws but do
not tighten.
―
NOTE
―
Blades will not heat up unless both blades are
fully inserted. Be sure to use the blades as a set.
3. Adjust and align the blades manually then
tighten the hexagon socket set screws with
the hexagon wrench to secure the blades.
Hexagon wrench
Hexagon socket set screw
(M2.5 × 2.5)
V-groove
1. Switch off the power and wait until the blades
have cooled down.
2. Remove the screws with the hexagonal
wrench and remove the blades using the main
body blade removal plate.
CAUTION
• When pulling out or inserting blades, be sure
that the power is switched off.
• Before pulling out the blades, check that the
blades have cooled down sufficiently.
4-1-3 Blade holder
The removed blades can be placed in the holder
as shown at right.
Hex wrench can placed in the position of the
arrow.
―
NOTE
―
Place the removed blade in the blade holder.
4-1 Blades
4-1-1 Attaching blades
4-1-2 Removing blades
Blade removal plate
Blade removal plate
Blade guard
