![background image](http://html1.mh-extra.com/html/hakko-electronics/fr-701/fr-701_instruction-manual_3297643007.webp)
5
5. INITIAL SETUP (Soldering iron)
6. OPERATION (Soldering iron)
Small sponge
pieces
Large sponge
CAUTION
Be sure the sponge is moistened with water
before use to avoid damaging the tip.
A. Setup the iron holder
1. Fit the small sponge pieces into the hollows of the iron
holder base.
2. Add an appropriate amount of water into the iron
holder base. The small sponge will absorb water
and help keep the large sponge damp at all times.
3. Dampen the large sponge and place it on the
iron holder base.
*When using a Cleaning Wire
Place it in the iron holder as shown on the right.
Push on the plug until
it stops, making sure it is
securely connected.
Receptacle
To disconnect, hold
the plug and pull it out
of the receptacle.
B. Connect the iron to the station
1. Connect the cord assembly to the receptacle.
2. Place the iron into the iron holder.
3. Plug the power cord into an appropriate power supply.
CAUTION
· Be sure to turn off the power before connecting or
disconnecting the cord assembly for the iron to and from
the receptacle to avoid damaging the circuit board.
· Do not use any iron other than those listed in Section
1 of this manual. Doing so may result in inadequate
performance and / or possible damage to the unit.
· The unit is protected against electrostatic discharge and
must be grounded for full efficiency.
●
Operation and indication
Switch and control button
SOLDER
DESOLDER
UP
DOWN
ENTER
POWER
FR-701
UP
ENTER
The front panel for Soldering iron has the
following two control buttons.
-
Use this button to select and change settings.
In the preset mode, pressing this button will change the selected
preset temperature while the unit is in operation.
Pressing and holding the button will start the adjust mode.
-
Use this button to make and confirm selections.
Pressing this button will display the current set
temperature.
Pressing and holding the button will start the temperature setting
mode.
6
B. After use
Always clean the tip and coat it with fresh solder after use.
(Refer to “Tip Maintenance” in 8. MAINTENANCE (Soldering iron).)
After turning on the power switch, will be displayed
for two seconds, and current temperature will be displayed.
When the display stabilizes, the LED heater lamp will begin to flash.
A. Operation
1. Turn on the power switch (main) located on the front.
2. Turn on the power switch (soldering iron).
LED heater lamp
Place the iron in the iron holder when not in use. Turn the power off
when the HAKKO FR-701 is not in use for an extended period.
CAUTION
A. The temperature setting mode (Changing the set temperature)
The temperature setting range is from 50 to 480 (from 120 to 899℉).
By default, the temperature is set to 350℃ (662℉).
Example : Changing from 350℃ to 400℃
The desired temperature is saved to the system memory.
Heater control will begin after the new set temperature is displayed.
●
Making Changes to Settings
CAUTION
If no buttons are pressed for at least one minute during the process of changing settings of the unit,
the system will exit and return to operating mode and display the current temperature.
Press and hold the
button for at
least one second.
Press the button
once.
Press the button
five times.
Press the button
once.
Press the button
once.
Press the button
once.