17
Turn the power
switch (desoldering
tool) ON.
Connect the hose.
Turn the power
switch (main) ON.
3. Set the HAKKO FR-4103 in the iron holder.
4. Connect the hose of the HAKKO FR-4103
to the vacuum outlet cap on the HAKKO
FR-701 station.
5. Plug the power cord into a grounded power outlet.
Ensure that the power switch is OFF before plugging
in the power cord.
CAUTION
Be sure to ground this product as it is ESD
safe by design.
7. Turn the power switch (desoldering tool) ON.
6. Turn the power switch (main) ON.
CAUTION
When not in use, place the handpiece in
the iron holder.
CAUTION
Be sure to hold the plug when inserting or removing the handpiece cord.
B. Station
●
Connection
1. Connect the power cord to the receptacle on the
rear of the station.
2. Connect the plug of the HAKKO FR-4103 to the
receptacle on the HAKKO FR-701 (Desoldering Tool).
CAUTION
Connect the plug to the receptacle, aligning the tab
on the plug with the opening on the receptacle.
Insert the plug into
the receptacle until
it seats.
To disconnect, pull the plug
of the receptacle while
pressing down the tab on
the plug.
Receptacle
12. INITIAL SETUP (Desoldering Tool) (continued)
18
13. OPERATION (Desoldering Tool)
SOLDER
DESOLDER
UP
Clogging
Indicator
DOWN
ENTER
POWER
FR-701
UP
ENTER
●
Operation and indication
Switch and control button
- Moving the cursor UP. Increases the value.
- Moving the cursor DOWN. Decreases the value.
- End of sequence (terminates a phase of a data
entry mode).
Normal display screen
C
1. Place the nozzle over the lead wire of the part to be desoldered
and begin heating.
Be careful to heat the lead wire and the solder, not the land.
Placing the nozzle directly in contact with the land may cause the
land to peel off. You may apply a small amount of solder to form a
heat bridge to help the heating process.
2. Check to make sure all of the solder on the joint has melted.
With the nozzle still in place over the lead wire, slowly move the
lead wire, being careful not to apply too much force. If the lead
wire moves easily, all of the solder has melted.
3. Pull the trigger to remove the melted solder.
Make sure that a filter has been inserted in the desoldering tool.
Desoldering without a filter may damage the pump.
4. If the solder was not removed, re-solder the part using new solder
and then repeat the desoldering process.
A. Desoldering
If the pump does not operate, immediately clean the nozzle
& heating element and replace the filter if necessary.
CAUTION
Nozzle
Board
Solder
Lead
CAUTION
