10. ERROR MESSAGE
●
Sens Error
●
Grip Error
●
Low Temp
●
Heater Short Error
●
Heat up Error
(For MODEL FM-2023)
●
Drive Error
(For MODEL FM-2023)
●
TRig Error
●
Zero-Cross Error
●
System Error
●
Det Error
EXAMPLE:
350
℃
(400
℃
- 50
℃
)
OR
650
℉
(750
℉
-
100
℉
)
Set temperature
Low-temperature alarm tolerance
Set temperature
Low-temperature alarm tolerance
When there is the possibility that a failure has occurred in the
sensor or heater (including the sensor circuit), "Sens Error" is
displayed and the power is shut down.
"Grip Error" will be displayed if the connector cord is not attached
to the station OR the wrong soldering iron is connected.
If the sensor temperature falls below the difference between the
current temperature setting and the low-temperature alarm
tolerance, "Low Temp" is displayed and the warning buzzer sounds.
When the tip temperature rises to a value within the set tolerance,
the buzzer will stop sounding.
"Heater Short Error" will flash, and the buzzer will sound
continuously, when the tip is inserted incorrectly, an incompatible tip
is inserted, or a foreign object has found its way into the connector.
This is displayed in cases such as when the iron tip abnormally
heats up relative to the set temperature when the micro-tweezers
(MODEL FM-2023) are connected.
This is displayed in cases such as when judged that an excessive
pulse has been generated when the micro-tweezers (MODEL
FM-2023) are connected.
A "trig error" will occur if the trigger is pulled before the nozzle
temperature has reached the set temperature. Please wait until the
temperature reaches the set temperature and stabilizes.
This is displayed when a zero-cross cannot be measured in the
designated cycle. Should this error be displayed, please contact
your HAKKO representative.
This is displayed when the system is unable to operate normally.
Should this error be displayed, please contact your HAKKO
representative.
"Det Error" appears on the display when turning the power on after
connecting the MODEL FM-2022/2023 with a hot tip.
This is not an error.
Wait for approximately 10 seconds until the model functions
properly.
EXAMPLE:
Assume that the temperature setting is 400
℃
/750
℉
and the
tolerance 50
℃
/100
℉
. If the temperature continues to decrease
and finally falls below the value indicated below while the heating
element is on, the displayed value starts blinking to indicate that
the tip temperature has dropped.
11. OPTION
●
External seitch (MODEL FM-2024)
An optional Foot Switch is available which can be connected to the unit to START/STOP the pump.
●
Security lock
The HAKKO FM-206 comes with an anti-theft security slot.
Compatible Slot Sizes
3 x 7 mm
(0.12 x 0.28 in.)
Foot switch
(B1649)
16
Summary of Contents for fm-206
Page 17: ......
