Hakko Electronics fm-206, Instruction Manual

Page: 10 / 19

6. PARAMETER SETTINGS
●
Password Lock Setting
When this function is activated, settings cannot be changed if the correct password is not entered.
Selection choices are as follows.
Password Lock
Setting
ON Partial OFF
A password is not included when it is shipped from the factory.
Immediately after the password lock is activated, it will move to
the password input screen.
●
Password
This is displayed when the password lock is activated, and you can enter and change your password. However,
as stated above, entering your password is necessary before almost all setting changes. This is also true when
you change your password, and when the first password input screen will be displayed.
Input Password
A * *
Set New Password
A * *
Alphabetic character
change
Accept
（ move the cursor ）
When changing the alphabetic characters, turn
the control knob, and when moving the cursor to
the next character, press the control knob.
When you enter the correct password, the monitor title will change from "Input Password" to "Set New
Password". If it is still on "Input Password," the correct password was not entered. Check your password
once more and then enter it.
Input Password
A A *
Input Password
A * *
Enter the last character
Input
failure
Successfully
entered
Return to the screen where you
enter the current password
New password setting screen
Here is how you
know you are on
the right page.
：
Password entry required when changing all settings
： Password entry not required only when setting the offset, but required for everything else
：
Password entry not required when changing all settings
Turn the control knob and highlight the desired item, then press the control knob when you have
made your choice. When the password lock is set to "ON" or "Partial," the item "Password" will
be added to the parameter settings. Here, password changes can be performed.
ON
Partial
OFF
Set New Password
A * *
Please refer to the "Password" section for how to enter your password.
Vacuum Mode
Setting
Normal Timer
After activating the password lock, you will be asked for your password before changing your settings in
the manner shown below, so please change your settings after entering your password.
Example: When setting the Vacuum Mode
Normal Timer
Input Password
A * *
Select
Accept
In the event you completely forgot your
password and cannot change your
settings, please contact your HAKKO
representative
10