Jack**(1, 2, 3)
Power
Receptacle
Fuse
Power Switch
Control Button(1, 2, 3)
Filter Case Cover
■
Part Names
Compatible with
FM-2024
FM-2026
FM-2027
Control Knob
Flow Control Knob
Air Output
Compatible with
FM-2022
FM-2023
FM-2024
FM-2026
FM-2027
FM-2030
FM-2031
Compatible with
FM-2024
FM-2026
FM-2027
FM-2029
FM-2030
FM-2031
* Each receptacle connector differs, please be careful not to connect an
incompatible device. Errors will result.
**For connecting iron holders. Make sure to connect the correct holder.
While both vacuum and hot air can be used, only one can be operated at once. One
cannot use a combination of hot air and vacuum or two vacuums simultaneously.
Jack
(equipotential)
Receptacle* (1, 2, 3)
Jack
(for foot switch)
I/O
CoverPlate
3. WARNINGS, CAUTIONS, NOTES AND EXAMPLES
Warnings, cautions and notes are placed at critical points in this manual to direct the operator’s attention to
significant items. They are defined as follows:
WARNING: Failure to comply with a WARNING may result in serious injury or death.
CAUTION : Failure to comply with a CAUTION may result in injury to the operator, or damage to the
items involved.
NOTE: A NOTE indicates a procedure or point that is important to the process being described.
CAUTION
When power is ON, the tip will be hot. To avoid injury or damage to personnel and items in the work
area, observe the following:
●
Do not touch the tip or the metal parts near the tip.
●
Do not allow the tip to come close to, or touch, flammable materials.
●
Inform others in the area that the unit is hot and should not be touched.
●
Turn the power off when not in use, or left unattended.
●
Turn the power off when connecting the handpieces or storing the HAKKO FM-206.
●
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
●
Children should be supervised to ensure that they do not play with the appliance.
●
To prevent accidents or damage to the HAKKO FM-206, be sure to observe the following:
●
Do not use the HAKKO FM-206 for applications other than soldering.
●
Do not strike the iron against hard objects to remove excess solder. This will damage the iron.
●
Do not modify the HAKKO FM-206.
●
Use only genuine Hakko replacement parts.
●
Do not allow the HAKKO FM-206 to become wet, or use it with wet hands.
●
Remove power and iron cords by holding the plug − not the wires.
●
Be sure the work area is well ventilated. Soldering produces smoke.
●
While using HAKKO FM-206, don’t do anything which may cause bodily harm or physical damage.
4. INITIAL SETUP
•
Please make sure the power is off when you plug in cables.
•
Please make sure to hook up the connector cable and the iron holder on the same
channel and not to place the iron in a holder connected to a differing channel.
•
Please take care not to mix up the hose connections, the MODEL FM-2024 connects
to the filter case cover and the HAKKO FM-2029 to the air output.
•
Securely insert the connecting cable all the way in to the jack.
CAUTION
■
Setup
●
Hooking up the iron and connecting cable.
Connecting
Cable
Plug the iron's connector
cord into the receptacle.
Plug in power and connecting cables.
Power
Cable
Connection for
FM-2024 Suction
Hose
Connection for
FM-2029 Air Hose
2
Summary of Contents for fm-206
Page 17: ......
