System configuration
Domestic air conditioner
Operation
Timer On/Off On-Off Operation
TURBO Operation
(This function is unavailable on some models.)
Press HEALTH button , the remote controller will show
and then achieve to the health function.
Press again this HEALTH button , the
health function will be
cancelled.
HEALTH Operation
(This function is unavailable on some models.)
a lot of anion effectively balance the quantity of position
up the dust sediment in the room and finally clean the
and anion in the air and also to kill bacteria and speed
air in the room.
The anion generato
r
in the airconditioner can generate
1.After unit starts, select your desired operation mode.
2.Press
/ button to change TIMER mode.
Then select your desired TIMER mode (TIMER ON or
TIMER OFF ). " "or " "will flash.
3.Press
/
button to set time.
Hints:
After replacing batteries or a power failure happens, time
setting should be reset.
According to the Time setting sequence of TIMER ON or
Press the button for each time, setting time in the first
12 hours increased by 0.5 hour every time, after 12
hours,increased by 1 hour every time.
After adjust the time,press
button and confirm the
time ON or OFF button will not flash any more.
4.Confirm timer setting
5.Cancel timer setting
TIMER OFF, either Start-Stop or Stop-Start can be
achieved.
TIME
OFF
TIME
ON
TIME
OFF
TIME
ON
Loading of the battery
1
2
3
4
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with th
e" + "/"-";
Load the battery,then put on the cover again.
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change- over
wireless telephone is installed in the
ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
type fluorescent lamp or
room, the recei
Note:
Full display or unclear display during operation indicates the
ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
batte
remove the batteries and
Press button "
0.5 " will appear ,after 10 seconds
the time display will be blank.
TIME
ON
ON
Press button "
0.5 " will appear ,after 10 seconds
the time display will be blank.
TIME
OFF
OFF
Press the button the time display eliminated.
Press the
cancel
（
TURBO
）
（
QUIET
）
When you need fast cool or fast dehumidification,you
can choose the Turob function; when you sleep, read,
you can choose Quiet function
bu on, you can switch the “Turbo”
and “Quiet”
will swith as below
When running in Turbo
，
the fan speed is the highest,
when running in Quiet, the fan speed is super slow
Turbo/Quiet
Auto
Cool
Heat
Dry
2
Turbo/Quiet
409
