6
# Remove the 2 x screws out of the pin that runs through the end of guard support arm.
Remove the blue fiberglass 45degree cutting shield out of guard assembly if fitted.`
Remove socket head cap screw out of guard bush cup
Fit the guard onto the end of the pipe and refit and fasten tightly the 2 x screws for the pin and the
socket head cap screw for the positioning rod
Fit 90 degree Standard Clear Perspex rear guard piece into overhead guard
Positioning and adjustment of overhead guard
The guard will now need adjusting to fit safely and correctly.
Swing guard assembly over blade position and lock in place if not already done.
Firstly adjust the guard so it is over the blade opening, central to the blade opening and parallel to the
blade slot.
Do this by adjustment of the swivel location bracket , the guard attachment pin (horizontal and
vertical slots).
And the main guard outrigger arm were
it is bolted to stand in the adjustable
slots to bring assembly over the slot
Guard should be adjusted so the blade
slot in table is central between the
guards guide rollers.
RH screw in Pin of
support arm
Guard bush cup
Socket head
cap screw
Horizontal slot
