4
Tighten the 2 x end screws with 10mm allen key supplied in tool bundle
Ensuring first that the table assembly is slid back to sit on the 2 x adjustable table setting screws that
have been factory set.
When these 2 bolts are tight unlock sliding table and slide table all the way to the right
(table should be 40-45mm as shown)
With table in this position
This will give you access to the hole for the middle table attachment screw hole fit screw up and
under into hole and tighten it firmly
Check table slides freely full travel both
directions.
Set table back in centre and lock table lever
Refit access cover and close electrical cabinet.
Sliding
table
Ensure table it against
these screw heads
(one each end)
