16
Setting height of Riving
Knife
The riving knife height can now be
set (just under height of blade cut)
Put a bit of scrap wood behind
main blade and wind blade up level
with the top of it.
Undo riving knife lock bolt and
move riving knife as needed to be
just under level of wood
Lock bolt tight
Lift up lower blade guard and push
back closed
Wind main blade all the way down
Setting measurement tapes on outrigger fence
Ensuring machine is not connected to power
Line outrigger table fence up with main blade (lock table in position)
Set rear measurement tape of fence
Slide out extension arm and measure with a
separate tape measure, 200cm from the saw
blade to the flip over stop on the end of the
extension arm. Lock extension in place
The measurement tape in the aluminum
extrusion can now be set to 200cm under the
magnifier line by unscrewing small knob
under the fence, sliding the tape in the slot as
needed and locking the knob again
(NB ends of metal tape in the slot may have
to be trimmed to suit)
Final adjustment can be done after taking a
test cut and re-measuring at a later date
Ensuring machine is not connected to power
Set front measurement tape of fence
Flip over a length stop measure with a separate tape measure, 100cm from the saw blade to the flip
over stop on the fence.
The measurement tape in the aluminum extrusion can now be set to 100cm under the magnifier line
by unscrewing small knob under the fence, sliding the tape in the slot as needed and locking the knob
again
(NB ends of metal tape in the slot may have to be trimmed to suit)
Final adjustment can be done after taking a test cut and re-measuring at a later date
Front fence tape setting
knobs
