HAEMMERLIN 312175001, Instructions For Use Manual

Page: 63 / 88

63
BALCONY CLAMP
The balcony clamp allows the ladder structure of the hoist to be positioned and locked perpendicular to the
building façade on a balcony or a concrete floor.
Adjusting the balcony clamp:
- Unscrew the clamping handle (1).
- Remove the clip pin to release the sliding spur (2).
- Adjust the position of the sliding spur on the rod so that the space between the base of the clamping
handle and the fixed spur is slightly greater than the thickness of the balcony or the concrete floor
where the balcony clamp (3) will be installed.
- Replace the clip pin to lock the sliding spur.
Installation of the balcony clamp:
- Bring the balcony clamp to the level of the balcony or concrete floor (1).
- The vertical tube must be in contact with the edge of the balcony or the concrete floor.
- Secure the balcony clamp by turning the clamping handle with a properly shaped tube (2). The
minimum tightening torque to be applied to the clamping handle is 50Nm.
- Proceed in the same way to install the other balcony clamps on each floor ensuring that all the
following balcony clamps on the upper floors are perfectly aligned vertically.
1
2
3
1
2