10-8
Table 10-2 display wlan client verbose
command output description
Field
Description
MAC Address
MAC address of the client
AID
Association ID of the client
Radio Interface
WLAN-Radio interface
SSID
The SSID with which the client is associated
BSSID
ID of a BSS
Port
WLAN-BSS interface associated with the client
VLAN
VLAN to which the client belongs
State
State of the client such as Running
Power Save Mode
Client’s power save mode such as Active or Sleep
Wireless Mode
The wireless mode, which includes 802.11a, 802.11b,
802.11g, 802.11gn, 802.11an at present.
Support for wireless mode depends on your device
model.
QoS Mode
z
WMM indicates that the WMM function is
supported;
z
None indicates that the WMM function is not
supported.
WMM information negotiation is carried out between
an AP and a client that both support WMM.
Listen Interval (Beacon Interval)
Specifies how often the client wakes up to listen to
beacon frames and is expressed in units of beacon
interval.
RSSI
Received signal strength indication. This value
indicates the client signal strength detected by the AP.
SNR
Signal to Noise Ratio
Rx/Tx Rate
Represents the receiving/sending rate of frames such
as data, management, and control frames
Client Type
Displays the client type such as RSN, WPA, and
PRE-RSN
Authentication Method
Authentication method such as open system or
shared key
AKM Method
AKM suite, such as Dot1x, PSK
4-Way Handshake State
Displays either of the 4 way handshake state:
z
IDLE: Displayed when initial state
z
PTKSTART: Displayed when the 4-way
handshake is initialized.
z
PTKNEGOTIATING: Displayed after sending valid
message 3.
z
PTKINITDONE: Displayed when the 4-way
handshake is successful.
