Operation Manual – CLI
H3C S5600 Series Ethernet Switches
Chapter 1 CLI Configuration
1-7
IV. Switching to a specific user level
Follow these steps to switch to a specific user level:
To do…
Use the command…
Remarks
Switch to a specified
user level
super
[
level
]
Required
Execute this command in user view.
Note:
z
If no user level is specified in the
super password
command or the
super
command, level 3 is used by default.
z
For security purpose, the password entered is not displayed when you switch to
another user level. You will remain at the original user level if you have tried three
times but failed to enter the correct authentication information.
V. Configuration examples
After a general user telnets to the switch, his/her user level is 0. Now, the network
administrator wants to allow general users to switch to level 3, so that they are able to
configure the switch.
1)
Super password authentication configuration example
# A level 3 user sets a switching password for user level 3.
<Sysname> system-view
[Sysname] super password level 3 simple 123
# A general user telnets to the switch, and then uses the set password to switch to user
level 3.
<Sysname> super 3
Password:
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
# After configuring the switch, the general user switches back to user level 0.
<Sysname> super 0
User privilege level is 0, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
2) HWTACACS
authentication configuration example