Operation Manual – MSTP
H3C S5600 Series Ethernet Switches
Chapter 1 MSTP Configuration
1-33
Note:
You are recommended to configure the Ethernet ports connected directly to terminals
as edge ports and enable the BPDU guard function at the same time. This not only
enables these ports to turn to the forwarding state rapidly but also secures your
network.
III. Configuration example
# Configure GigabitEthernet 1/0/1 as an edge port.
1)
Configure GigabitEthernet 1/0/1 as an edge port in system view
<Sysname> system-view
[Sysname] stp interface GigabitEthernet 1/0/1 edged-port enable
2) Configure
GigabitEthernet 1/0/1 as an edge port in Ethernet port view
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp edged-port enable
1.3.13 Specifying Whether the Link Connected to a Port Is Point-to-point
Link
A point-to-point link directly connects two switches. If the roles of the two ports at the
two ends of a point-to-point link meet certain criteria, the two ports can turn to the
forwarding state rapidly by exchanging synchronization packets, thus reducing the
forward delay.
You can determine whether or not the link connected to a port is a point-to-point link in
one of the following two ways.
I. Specify whether the link connected to a port is point-to-point link in system
view
Follow these steps to specify whether the link connected to a port is point-to-point link in
system view:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Specify whether the
link connected to a port
is point-to-point link
stp interface
interface-list
point-to-point
{
force-true
|
force-false
|
auto
}
Required
The
auto
keyword is
adopted by default.
