9
4. Sand the leading edge to the section shown on the plan.
5. Bend the 4mm stainless steel tube to form the trailing edge of the elevators
according to the shape on the plan. Then drill 2 x 4mm holes
for
each elevator
in the 10x10mm wood leading edge for the stainless steel tube to fit into. Note:
These holes must be drilled at the angles shown on the plan. When satisfied
with the fit and alignment, glue the stainless steel tube into place using CA glue.
6. Reinforce the elevator ribs on both elevators using 1mm pine wood capping strips top and bottom. Glue a mounting block in each elevator
in the position shown on the plan for the control horns. Trim the excess off the capping strips and then sand smooth to the stainless steel
tube.
