Gyyr TLC2100-S16, Operating Instructions Manual

Page: 78 / 84

68 TLC2100-S16
1837-0700-4852542C
Continued from previous page
PROBLEM CHECK
FOR MORE INFO IN
MANUAL
Picture on monitor jitters
during playback Try one or combination of the following during time-
lapse playback:
Adjust Horizontal and Vertical Hold on monitor.
Adjust Tracking controls on front panel.
Adjust V-Lock on front panel with VCR in Still
mode. Controls
"Alarm" light flashing in Digital
Display An Alarm has occurred. Press "Alarm Reset" button
to clear. Controls
Tape will not eject Check if "Lock" is lit on the Digital Display.
Deactivate Lock mode or contact supervisor.
Momentarily remove AC power, then check warning
codes. Controls
Appendix C: Warning Codes
Unit does not start rerecording
after rewind Check the Recycle options setting in Alarm Record
Options menu. Menus
Cannot change programming Is unit in Timer mode? Deactivate Time mode.
If operating any of the units functions, put unit in
Stop mode.
Check if "Lock" is lit on the Digital Display.
Deactivate Lock mode or contact supervisor. Controls
Menu programming does not
hold after power loss Keep unit powered for a minimum of 24 hours to
charge internal battery. Menus
"Error" is lit on Digital Display Unplug AC power to VCR, wait 5 seconds, restore
AC power. Immediately press "Eject" button to
extract tape. If unit repeatedly goes into "Error
condition, service is required. Appendix C: Warning Codes
Cannot display VCR menu on
monitor Check cabling. If unit is connected to a device such
as a quad or multiplexer, set device to "play/view",
"live", or other setting to access VCR menu. Getting Started
Controls
Menus
Bad or distorted images in Play
mode Adjust tracking controls. Set 6-hour control to 12
o'clock position. Set slow tracking to 10 o'clock
position. PControls
VCR does not change speed
during alarm Review setting in Alarm Record Option Menu.
Verify correct Alarm Input wiring to the VCR.
Manually short the Alarm Inputs pins 1 to 15 and
verify the VCR recognizes the alarm. Controls
Menus
Appendix A: External Interface
Monitor video appears washed
out The video input signal is not terminated correctly or
is not set at the correct level. Controls
Menus