P/N G610B
April, 2016 (Rev 0)
Page 8
TOOLS REQUIRED FOR SYSTEM INSTALLATION
11/32” Nut Driver
1" Hole Saw
Tape Measure
Electric Drill
Phillips #2 Screwdriver
Safety Goggles
INSTALLATION INSTRUCTIONS
Before beginning the installation of your Guardian
G600-B unit, locate and identify each part.
(See
FIGURE 1)
Turn off the circuit breaker to the kitchen
range hood and stove before boring holes. Wear
approved safety goggles. Protect stove top and counter
surface from falling debris.
Note:
Installation is not considered complete until “Arming the
System” is performed as outlined on page 15.
Perform the following:
1. Assemble all suggested tools. Remove all
components from the box and familiarize yourself
with assembly components.
2. Review assembly procedures and check physical
height and width requirements of cabinet above or
beside vent hood. Also check minimum and
maximum height requirements for nozzles and
sensors.
(
See
FIGURE 5
)
3. Plan your installation by selecting the desired
location of the Guardian G600-B System Enclosure
/ Extinguisher Assembly. The Guardian G600-B is
usually on the left side of the cabinet directly above
the hood or microwave hood, however; right side
mounting or side cabinet installation is an option.)
(See
Figure 6
)
4. Determine the best route from below the hood to
the location of the Extinguisher Assembly.
Before
Drilling,
measure the route and make certain that
the sensor cable and stainless steel braided hose
are long enough to connect to the Guardian G600-
B System Enclosure / Extinguisher Assembly in its
desired location. The stainless steel braided hose,
sensor wire and interconnect cable can route
through the same set of holes.
5. Using your electric drill and 1” hole saw, drill any
holes required for your planned route avoiding
damage to any existing wires, plumbing, etc. that
may be along the chosen route. Clean up any
dust/debris made while drilling.
6. Carefully remove the main CPU housing from the
Guardian G600-B System Enclosure / Extinguisher
Assembly by loosening the thumb screw and
removing the front cover of the enclosure -set
cover to the side (See
FIGURE 2
). Using your #2
Phillips driver, loosen the three silver screws in the
teardrop slots inside the main CPU housing. Two
are on the left side (top and bottom) and one on the
right side (top). Once they are loose the main CPU
housing can be removed by sliding the housing
slightly up and then away from the cylinder- set
CPU housing to the side.
(See
Figure 2
)
7. Place the Guardian G600-B System Enclosure /
Extinguisher Assembly in its desired location and
fasten the base with two screws installed through
the two holes located on the front corners at the
base of the housing. (See
Figure 6
)
FIGURE 5
SYSTEM INSTALLATION INSTRUCTIONS
COOKING
SURFACE
Two Screw
Holes
FIGURE 6
FLAT FACE
HOOD
FLAT FACE
MICRO
HOOD
Permit Number:
20-04649
