58
Minute, 2 Minutes, 5 Minutes, 10 Minutes and Manual Stop. If you select “Manual’
option, the alarm output will not stop until you press “Clear Alarm” button in
“Utilities” menu. So the actual alarm output time is made up of alarm input time and
this delay time.
Step 3: Enter alarm out schedule
You can set the schedule to enable alarm output. Move “Active Frame” to
“Schedule” button on right side of “Alarm Out Time” item, press[ENTER]key to
enter the corresponding schedule menu: Shown as Fig.5.26 below
Fig. 5.26 Alarm out schedule
Step 4: Setup alarm out schedule
Like other schedule setup, you can set 4 time periods for one day and 7 days for
one week. When you finish setup, press “Confirm” button to return “Alarms” menu.
Step 5: Copy one alarm output parameters to other alarm output
In “Alarms” menu, you can copy parameters of current alarm output to other
alarm output.
Step 6: Save setup
When you finish setup, in “Alarms” menu, press “Confirm” button to save all
parameters.
Note: If any schedule is modified, you must reboot DVR to make it become
effective.
Exceptions
The exceptions can be handled at present include: hard disk full, hard disk error,
illegal access, IP address conflict, network failure, and NTSC/PAL differ.
Enter “Exceptions” menu: Shown as Fig.5.27 below
