- 45 -
5.5.2 HTTP Port
It is used to connect to the DVR web server. By default the value of the port is 80. You can
specify a different port number.
5.5.3 Command Port
It is used to control the DVR. By default the value of the command port is 5050. You can
specify a different port number.
5.5.4 Media Port
This port is used for audio and video stream. By default the value of the media port is
6050. You can specify a different port number.
5.5.5 PPPoE Settings
The following settings are located on the second page
of the
Net
Tab. Press
Next Page
to open these options.
You can activate or deactivate (ON/OFF options) PPPoE settings. The changes will
take effect after you save them.
HTTP port: 80, Command port: 5050, Media port: 6050 and
Mobile surveillance port: 7050 must be open/allowed to upload
to WAN interface if the DVR is behind a Firewall server.
If the DVR is installed behind a Router to share a single public
IP address, be sure to configure the “Port Forwarding” or
“Virtual Server” for those three network ports and the Mobile
surveillance Port: 7050.