23
Setting the Closed Position Limit
for Pull to Open Applications
TURN CONTROL BOX ON
Your GTO PRO® has two Limit Settings
1)
OPEN Limit setting:
(Gate in the OPEN POSITION / the limit is FACTORY SET and NOT ADJUSTABLE) The open
limit setting is the fully open position. The tube must be fully retracted.
2)
CLOSED Limit setting:
(Gate in the CLOSED POSITION) To achieve optimum closed position, you are required
to complete the following FOUR STEPS:
Step 1
Confirm that the power switch is in the ON position and the gate
is in the OPEN POSITION.
Step 2
Activate your opener by pressing the entry transmitter button.
Your gate should now be moving from the fully open position
toward the closed position. Prepare to STOP the gate by pressing
the entry transmitter button again when the gate reaches the
desired closed position. This step may be repeated until desired
close position is achieved. Once the desired CLOSED position
has been achieved, proceed to step 3.
Step 3
With the gate in the desired closed position PRESS & HOLD
the “LEARN MAST LIMIT" button on the control board for 5
seconds.
Step 4
Press the transmitter button and allow the gate to return to the
fully open position. YOUR GATE’S CLOSED POSITION LIMIT IS NOW PROGRAMMED.
TESTING YOUR CLOSED LIMIT SETTING:
Press your entry transmitter and allow your gate to close. If the CLOSED position is not correct or needs to be changed, you
will need to CLEAR your CLOSED LIMIT settings and follow Steps 1-4 again.
CLEARING THE PROGRAMMED CLOSED LIMIT SETTING:
If you make a mistake and set the limit at the wrong position – press your transmitter to return the gate to the fully opened
position, then press and hold the "LEARN MAST LIMIT" button for 5 seconds. This will clear the memory for the closed
limit position. Follow Steps 1-4 again.
Learn Master Limit
Button
1
2
3
4
O
N
D
IP
STATUS
LEARN RMT
LEARN
MAST LIMIT
LEARN
SLV LIMIT
S3
S4
S2
ART OFF
G OFF
PULL
EN DLY.
OFF
OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN
MAX
CLOSE TIME
STALL FORCE
NOTE:
For heavier gates you may need to increase the stall force (see pg 24). If the gate still does not open or close to the
limits you have set, check to ensure that the gate installation was performed correctly according to the guidelines set forth on
page 11. If the transmitter does not activate the gate operator you may have to reset the transmitter code (see pg 25).