5. Control System
PNEG-696
TopDry Series 2000 Autoflow
17
Fans Off Delay
- The fans off delay allows the fan and heater unit(s) to be shut down during the dump
cycle. This will prevent the drying floor from becoming excessively dirty when there is a large amount of
foreign material present in the grain being dried. There are two values that the fans off delay can be set
at presently: 1:00 and 0:00. Use the increase and decrease buttons to select the value. When set at 1:00
the fan and heater units will shut off during the dump cycle. When CONTROL SYSTEM set at 0:00 the fan
and heater unit(s) will not shut off and the unit will operate normally.
Set-Up: Standard
The following Options are Set by Pressing the Setup Button
Out of Grain Timer
- This timer counts down when the fill system(s) start and will shut them off when it
has timed out. Default time is 20 minutes.
Clear Total Batches
- Press the reset button to clear the total batches. Press the enter button to continue.
Clear Warning History
- Press the reset button to clear the warning history. Press the enter button to
continue.
Time Until Load OFF
- In Autobatch mode is the percentage of time through the dry cycle that the fill
systems will be shut off regardless if the dryer is full or not. Press the enter button to return to the main
drying screen. This feature is only shown in Autobatch mode.
Set-Up: Extended
The set-up mode is used to program the computer with different variables that influence how the dryer will
operate. This mode is accessed by holding in on the modify button when turning on the control panel.
Set Date
- Use the increase and decrease buttons to select the correct day of month. Press the enter
button when the correct day of month is displayed.
Set Month
- Use the increase and decrease buttons to select the correct year. Press the enter button
when the correct month is displayed.
Set Year
- Use the increase and decrease buttons to select the correct year. Press the enter button when
the correct year is displayed.
Set Hour
- Use the increase and decrease buttons to select the correct hour. Press the enter button when
the correct hour is displayed.
Set Minute
- Use the increase and decrease buttons to select the correct minute. Press the enter button
when the correct minute is displayed.
Air Switch
- Use the increase and decrease buttons to toggle between enabled or disabled. If disabled is
selected the dryer does not require proof of airflow before the burner lights. If enabled is selected the dryer
requires proof of airflow to light the burner. Each time the dryer control power is shut off the Air switch test
defaults to enabled.
Wet Tank Switch
- Use the increase and decrease buttons to toggle between enabled and disabled. If
the disabled the computer will ignore the status of the Wet Supply Rotary switch. If enabled the dryer will
monitor the status of the Wet Supply Rotary switch.
Start Fans with High
- Determines whether the drying fan(s) will start with the drying chamber high level.
Use the increase and decrease buttons to toggle between enabled or disabled. In most situations the
fan(s) should be started with the Drying Chamber High Level Rotary switch. When the Drying Chamber
High Level Rotary switch is selected to control the starting of the main drying fan(s) the dry cycle and main
drying fan(s) will not start until grain reaches the Drying Chamber High Level Rotary switch.