GSi AIRSTREAM, Owner'S Manual, Page: 19 / 34

18
INSTALLATION
Install the 90° Elbow.
Slide a 6" Compression Clamp over the end of the 6' Tube
Weldment so the tube extends to the center of the clamp.
Tighten the bolt closest to the tube to hold the clamp in place.
Insert the
90 ° ° °
° °
Elbow into the clamp.
Align the elbow so the tube runs perpendicular to the screen side of the
dryer.
Tighten the remaining clamp bolts to hold the elbow in place.
Install the 3' Tube Section.
Slide a 6" Compression Clamp over the end of the 90 ° ° °
° °
Elbow so the
elbow extends to the center of the clamp.
Tighten the bolt closest to the elbow to hold the clamp in place.
Insert the
3' Tube Section into the 6" Compression Clamp.
Tighten the remaining clamp bolts to hold the tube in place.
Place the Cyclone Assembly
onto the end of the 3' Tube
Section.
Position the 6" Compression Clamp on the Cyclone Assembly so
half of the clamp is on the end of the tube.
Tighten the bolt closest to the cyclone to hold the clamp in place.
Position the
Cyclone Assembly onto the end of the 3' Tube Section.
Align the Cyclone Assembly vertically with the dryer.
Tighten the remaining clamp bolts to hold the cyclone in place.
Install the Cyclone Support.
Bolt the Cyclone Support to the Cyclone Assembly using the 3/8" x
4.00" Bolt and 3/8" Wide Flange Whiz Nut provided.
Bolt the other end of the Cyclone Support to the closest bolt on the
dryer that the support will reach when rotated to the dryer.
Note: This bolt is usually the bolt directly above the Blower
Mounting Bracket on the outer seam of the basket, however, a
9/32" hole may have to be drilled and a 5/16" Self Tapping
Screw used to secure this support to the dryer.
Basic Aspirator cyclone and exhaust tubing.
Cyclone support bolt location.
Cyclone Assembly