GSI Group PNEG-1813, Installation And Operation Manual

Page: 36 / 58

3. Operation Procedures
36 PNEG-1813 Electronic Distributor Control
2. On the “Move Position” screen, select the position you want the spout to move to by
pressing the spout name on the screen.
3. The “Main Menu” screen will now display a flashing message “Moving to” at the top of the
screen, the selected spout number will flash yellow while the pointer is moving to the
selected spout. The destination spout number will turn green when the move is complete.
4. Once the spout has finished moving, visually check and verify the spout is centered
with the distributor discharge spout. If alignment requires adjustment, see “Position
Locations Screen”
on Page 38 to adjust the positioning.
5. Repeat procedure for any other spouts that were repositioned.
Setup Menu Screen
Figure 3H Setup Menu Screen
Configuration Setup: Displays the machine setup screen that allows the user to change
the distributor’s parameters or reload default values. See “Configuration Setup Screen” on
page 37.
Position Names: Allows the user to assign or change the name of each spout position, and
to create or change a name for the distributor. See “Position Names Screen” on page 38.
Position Locations: Displays the positioning screen which allows the user to set the value
that aligns the spouts with the distributor. See “Position Locations Screen” on page 40.
Position Lock-out: Allows the user to lock or unlock spouts from being used. See “Position
Lock-Out Screen” on page 42.
Homing Interval: Allows the user to set the number of times before the “Perform Homing
Now” warning appears. See “Homing Interval Screen” on page 43.
Perform Homing Now: Press this to perform the homing operation to re-calibrate the
distributor.