GSI Group PNEG-1813, Installation And Operation Manual

Page: 16 / 58

2. Installation
16 PNEG-1813 Electronic Distributor Control
Encoder and Bracket Installation
Install the encoder (DEC0017) to the encoder mounting bracket (DEC0016) using the three #10-32 bolts
(S-10167) and #10 washers (S-7223) as shown in
Figure 2H .
Tighten the encoder collar set screw as shown in Figure 2I to 8 in-lb.
Install the encoder mounting bracket (DEC0016) to the proximity sensor bracket (DEC0006) using the
1/4”-20 x 3/4” HHCS bolt (S-1429), 1/4” washer (S-2126), and 1/4”-20 nylock nut (S-7025) as shown in
Figure 2J .
Figure 2H Encoder to Mounting Bracket
Encoder
(DEC0017)
#10-32 Bolt
(S-10167)
#10 Washer
(S-7223)
Encoder mounting bracket
(DEC0016)