Sheet 72.17
Parts F78, F88,H27, S23
●
Cut slots in the covering material for the horns on the control surface.
●
Sand the horn’s tabs as shown in the figures (red circles).
●
Insert into the slots and glue the horns F78 (spoilers) and F88 (aileron inside and
outside) (thin CA).
65
Long pieces bundle
Parts R56
Small parts bag
Parts R58, R59, R60, F76
Sheet 72.14
R57
●
Figure 1 Establish the hatch lock from a scrap piece of guide tube R56 and cable R29
and glue it in the battery hatch. (5 minutes epoxy).
WARNING:
Do not allow adhesive into the guide tube. When using the magnetic closure,
use
bar magnet R65; Check the polarity of the magnet when gluing in place of the wire lock.
●
Figure 2 Sand and clean the ends of the cables R56 for rudder and elevator control
rods. Solder a threaded coupler R59 on the end of the control rods and then add a nut
R60 and clevis R58. Install the servo tray and servos and adjust the control
rods/cables.
●
Figure 3 Motor installation. Use a small 2 mm piece of balsa to hold the motor wires
(thick CA). The propeller and the spinner are mounted only after the adjustments.
●
Figure 4 Use velcro to attach the battery to the fuselage side wall.
Summary of Contents for F5J
Page 38: ......