51
Sheet 72.12
Parts F64,
F65
Small parts
bag Part
F67
Sheet
72.04
Part F66
●
Figure 1 Shows the joiner for the outer wing sections. Glue parts F64 (2 pieces) and F65
(2 pieces) together (thick CA).
●
Figure 2 Sand (roughen up) and degrease the joiner rod where it will be glue. Slide the
joiner rod into the hole in the wing joiner tube, ensuring that it is correctly aligned. The
rod should protrude approximately 1 mm from the straight end and 55 mm from the
other. Glue the joiner tube in place (90 minutes epoxy).
●
Glue two filler doublers F66 together (thick CA). Repeat for the other two filler doublers.
●
Checkfit and glue these doublers to secure the joiner rod F67 (thin CA).
51
Sheet 72.17
Parts F71
●
Sand the connector F71 at the splices so that it fits into the spars F21 and F43.
WARNING:
The connector should slide in easily, any force required may damage (splice)
the spar. Remove the connector.
●
Figure 1 Apply glue to the inside of the spartubes F21 and F43 (where the joiner will
come to rest) edge of the connector piece on the thinner side.
●
Figure 2 Insert the connector into the spar F45 (only the thinner side) and remove
excess adhesive (90 minutes epoxy).
●
Figure 3 Ensure correct vertical orientation of this spar connector until the epoxy sets.
Summary of Contents for F5J
Page 38: ......