●
Figure 4 Apply glue to the faces of ribs F45 and F32 and the edges of the connector F71
that fit into spar F21 (90 minutes epoxy) and slide the wing sections over the wing
connector, removing excess glue. Clamp ribs F45 and F32 until the epoxy sets.
53
●
Figure 1 Apply glue to the inside of the spar F21. Apply glue to to the spar joiner
rod assembly from step 49 (90 minutes epoxy).
●
Figure 2 Slide the spar joiner rod assembly into into F21 removing excess glue.
●
Figure 3 Ensure the end of the joiner rod assembly is flush with the connecting rib and
that the rod is aligned vertically.
54
●
Figure 1 Seal the end of the wing joiner tube assembly by applying a transparent adhesive
tape onto the protruding end of the tube, its side, and over the F19 endpiece. Trim tape flush
around the F19 endpiece. This is to prevent glue from getting into the tube.
●
Figure 2 Apply another piece of adhesive tape to the other end of the assembly (the
beveled end). This is intended to prevent the assembly from sliding too far into the spar
and also holds the assembly until the glue sets. Apply glue to the inside of spar F1 with a
long stick. Apply glue to the wing tube joiner tube assembly. Insert assembly in the spar
Summary of Contents for F5J
Page 38: ......