●
Fold the covering over the leading edge and iron the covering to the trailing edge and
onto the flaps.
●
Iron the covering to the lower part of the root ribs, and cut off with 3 mm overlap
●
Shrink covering starting from the center, starting either from top or bottom. It is important
that the covering has thorough adhesive contact to all ribs before shrinking.
WARNING:
Carefully heatshrink the outermost panels to avoid warping of the center ribs.
61
Wing
●
The procedure for covering the outer wing panels is the same.
●
Cut out the covering for all wing panel with enough overhang.
●
Fix the ailerons with a small strip of covering (Figure 1)
●
Iron the covering onto of the ailerons (completely), cut off with 3 mm overlap, and iron
onto the top of the wing.
●
Fold covering over the leading edge (Figure 2), and iron to the bottom of the wing up and
including the aileron, with 3 mm overlap (Figure 3), ironing the overlap around the edge.
●
Cut the bottom slot for the ailerons free (Figure 4) then iron the leftover.
WARNING:
Carefully heat shrink the outermost panels to avoid warping the center ribs.
Summary of Contents for F5J
Page 38: ......