49
Small part
bag
Part F20
Sheet 72.09
Parts F17
●
Figure 1 Sand (roughen up) and degrease the brass tube F20.
●
Figure 2 Slide the brass tube carefully into the holes in the wing joiner until
the angled/skewed side is flush.
●
Figure 3 Glue in the brass tube (90 minute epoxy).
●
Figure 4 Checkfit, then glue two F17 fillers to retain the brass tube on one side of the
wing joiner (thin CA). Repeat with the other two F17 fillers.
50
●
Gently sand the holder to fit snugly, but not tightly, into the spar.
●
NOTE:
Build experience
from the EN translators suggests to m
ake it slides in
easily, too snugly might split/splice
your spar!
Summary of Contents for F5J
Page 38: ......