24
106205_06_07_08
Revision date: 08.30.18
Install End Wall Cladding
END PANEL INSTALLATION
After end frames are assembled, install
polycarbonate panels. Steps that follow describe
one way to complete panel installation.
Materials and parts needed to install end panels
include:
• Polycarbonate panels, DH8007 foil tape &
104774 vent tape
• Aluminum U-Channel (104213) & 104548 End
Cap
• Aluminum 8' H-Channel (113236Z096)
• Tek screws (FA4484B) & Neo-bonded,
galvanized washers (102921B)
Read the following information before starting:
• U-channel (104213) used to finish bottom of
some polycarbonate panels.
• Aluminum 8' H-Channel used to join two (2)
separate polycarbonate panels at seam.
• FA4484B Tek screws and 102921B galvanized
washers used to secure aluminum channel and panels to frame.
• Install polycarbonate panels with UV-protected side toward the sun. Mark side with a marker or piece of tape if needed after removing protective film.
ATTENTION:
Remove protective film from panels.
Allowing film to remain intact and in direct sunlight will make it difficult if not impossible to
remove.
• During preparation, rest panel edges on cardboard or other material to protect them from dirt and damage.
• Seal bottom edge of panels with vent tape.
• Consult polycarbonate panels (Quick Start section) for location and dimensions of each panel. Diagrams are located near back of these instructions.
ATTENTION:
Position panels as shown on diagrams. Using a panel in the incorrect place can affect placement of subsequent panels.
INSTALLING ACCESSORIES
Install all accessories (fans, vents, heaters, etc.) after installing all polycarbonate sheets.
Apply vent tape along bottom of these
panels
and
install 104213 U-channel
over tape to finish bottom edge.
Seal open cells of panel tops using foil
tape. Flashing will cover panel top and
sides once panels are installed.
Attach 104213
U-channel to panel
edges adjacent to
door opening.
Attach 104548 end cap to panel
edge above door opening after
door installation.
