17
Revision date: 08.30.18
106205_06_07_08
End Wall Frame — Accessories Note
A NOTE ABOUT INSTALLING END WALL FRAMING FOR OPTIONAL HEATERS, VENT FANS, AND MOTORIZED SHUTTERS (if equipped):
Optional accessories such as heaters, vent fans and motorized shutter units are typically installed in end walls of this greenhouse. Additional horizontal framing
(included) is installed
between
vertical end wall frame tubes to mount these accessories. Spacing shown for end wall supports on end frame diagrams may be
too narrow for installation of some larger accessories.
Diagrams typically do not show framing for accessories.
When framing end wall, consult installation instructions for accessories (if equipped), or measure width of accessory to accurately space and position end
frame tubes.
Consult panel installation diagrams in Quick Start section to identify verticals that can be moved.
Before installing any greenhouse accessory, adhere to the following:
• Consult end frame diagrams
before
installing accessory horizontal framing.
• If labeled, move only those verticals labeled as "NON-CRITICAL" on end frame diagrams when deciding where to install additional horizontal framing for
accessories.
NOTE:
Some vertical frame tubes must remain in locations shown on end frame diagrams. Polycarbonate panel installation requires specific on-center
spacing.
Moving critical end frame tubes can compromise end panel installation.
• Consult diagrams in Quick Start section showing polycarbonate panel locations and locations of aluminum trim and profile before repositioning any end
wall vertical.
• DO NOT REPOSITION END WALL VERTICALS USED AT SEAM OF TWO (2) POLYCARBONATE PANELS.
• Always consult installation guides that shipped with the accessory for additional precautions, recommendations, and safety requirements.
• Before installing any electrical accessory, consult a professional electrician for precautions and additional assistance.
• For gas heaters,
a professional, qualified service technician must install the unit.
Complete these steps to install accessory framing:
1. Based on installation requirements and precautions of the accessory, choose a location to mount accessory, and cut a 1.5" x 1.5" frame tube to required
length for framing.
2. Attach these horizontal frame tubes between vertical frame tubes (at required height determined by installation instructions included with that accessory)
using QH1330 brackets.
