Gröne GTTS 15-1000, Diagnostics And Troubleshooting Manual, Page: 18 / 112

18
If the blade in whichever place touches the edge of the table, make sure to regulate the position
of the engine on the truck again before a cut is made, and then tighten all the blocking screws and lock-
ing nuts.
The GTTS machine has been also equipped with regulation of location of entire main guide rail against
the axis of the table. The regulation is performed by using two screws placed on both ends of the ma-
chine (Fig. L). In order to shift the guide rail, untwist the side clamps (1), and then loosen the lock-
ing nuts (2) and by tightening / loosening the screws (or just one – if needed) regulate the position
of the guide rail. In the end, the position of the screws (2) must be countered with nuts, and the side
clamps (1) have to be tighten properly.
2
1
Fig. L – the screw regulating the position of the guide rail against the table axis
Caution: before you start working, make sure that the table is well tightened, and the entire machine
should be placed on hard, stable ground and (if possible) levelled so that during cutting the worked
material does not slide on its own as a result of vibration. If there is such a possibility, provide constant
pressure on the worked material which will eliminate its self-moving. You can use e.g. carpentry clamps,
but make sure that the worked object allows for their proper mounting and that none of the arms
of the clamp is located in the axis of the cutting wheel.