Model T31634/T31635 (Mfd. Since 8/19)
-19-
Adjusting bevel to zero
1. Lift bevel lock handle to unlock tilt position
(see
Figure 15).
Figure 15. Bevel lock handle location.
Bevel Lock
Handle
Adjusting Bevel to 0˚
2. Pull bevel release pin and rotate cutting head
until bevel angle scale displays 0 degrees
(see
Figures 16–17).
Figure 16. Cutting head angle.
Bevel Release
Pin
Bevel Angle
Scale
Indicator
3. Remove bevel release pin knob from screw,
(3) M5-.8 x 12 Phillips head screws, and rear
cover (see
Figure 18).
Figure 18. Rear cover hardware.
Bevel Release
Pin Knob
Phillips Head
Screws
— If bevel lock handle and bevel release pin
have been disengaged and cutting head
does not rotate, bevel tilt lock nut may
have been overtightened for shipping. To
loosen lock nut, proceed to
Step 3.
— If bevel lock handle and bevel release
pin have been disengaged and cutting
head does rotate, advance to
Unlocking
Cutting Head on Page 20.
Figure 17. Bevel angle at 0 degrees.
4. Loosen bevel tilt lock nut in
1
⁄
6
turn incre-
ments until cutting head can be adjusted as
instructed in
Step 2 (see Figure 19).
5. Re-install rear cover then bevel release pin
knob.
6. Use bevel lock handle to lock head position.
Figure 19. Bevel tilt lock nut location.
Bevel Tilt
Lock Nut
Summary of Contents for T31634
Page 64: ......
