h7583 tenoning Jig
-11-
3. loosen the set screw on the micro-adjust col-
lar, then remove the micro-adjust assembly
from the rod, as shown in
figure 10.
4. remove the cap screws and washers secur-
ing the guide bar to the base plate, then re-
install the bar in the outward mounting posi-
tion, as shown in
figure 10.
5. thread the long set screw removed in Step 1
back into the middle, inward hole on the base
plate, then tighten down the jam nut to secure
it.
6. loosen the pointer screw and swing the
pointer out of the way for the next step.
7. place the slide plate over the upright set
screw, as shown in
figure 11.
8. slide the micro-adjust collar onto the rod,
align the micro-adjust screw with the thread-
ed guide shaft of the slide plate, then rotate
the knob clockwise until the collar is even
with the rod, as shown in
figure 12.
9. With one hand pressing the slide plate flat
against the base plate to properly align the
micro-adjust assembly, fully tighten the set
screw on the micro-adjust collar to secure it
to the rod.
10. re-position and secure the pointer, then
re-install the slide plate lock lever and flat
washer.
To mount the guide bar in the inward posi-
tion:
1. perform the outward mounting procedure
but install the guide bar using the left row of
mounting holes on the base plate.
figure 11. slide plate positioned over the base
plate.
figure 10. guide bar mounted in the outward
position.
outward
Mounting
position
rod
set screw
long
set
screw
figure 12. Micro-adjust assembly properly
positioned.
rod
Micro-Adjust
Collar
