-20-
h7583 tenoning Jig
7. turn the saw
OFF
, disconnect it from power,
then wait for the blade to come to a complete
stop.
8. loosen the clamp shoe, remove the
workpiece, then move the jig back to the front
of the table.
9. rotate the workpiece 180°, correctly clamp
it against the jig, verify the blade alignment
for the second structural cheek cut, then
repeat
Steps 5–8 to complete the cut (see
figure 25).
figure 25. Making the second cut.
11. turn the saw
OFF
, disconnect it from power,
wait for the blade to come to a complete stop,
then remove the jig and additional base piece
from the table.
10. position the workpiece for the third and fourth
cosmetic cheek cuts, as shown in
figure 26,
and repeat
Steps 5–8 for each cut.
figure 26. Making the third and fourth cheek
cuts.
If it is necessary to remove the side support
plywood to perform a cut, make sure the
metal side support of the jig stays at least
1
⁄
2
" away from the saw blade at all times. If
the jig makes contact with the saw blade,
serious personal injury could result and
damage will occur to the saw and jig.
