Figure 34. Layer Parameter dialog box.
Model G0911–G0914 (Mfd. Since 05/21)
-33-
2. Double-click layer to open "Layer Parameter"
dialog box (see
Figure 34).
3. Set "Is Output" to "Yes" (see Figure 34).
Note: Setting layer output to "No" will prevent
that layer from being cut/engraved.
4. Set desired cutting/engraving speed in mm/s
(see
Figure 34).
Note: Slower speeds will create darker
engravings and deeper cuts on workpiece
(see
Cutting/Engraving Tips on Page 40 for
more details). This setting can be changed
during operation on Model G0911–G0914's
control panel.
5. Set "If Blowing" to "Yes" (see Figure 34).
IMPORTANT: This setting enables exter-
nal extraction fan to be turned
ON (Yes) or
OFF (No) when selected layer is running
and should always be set to "Yes" for safest
operation.
6. Set "Processing Mode" to "Cut" or "Scan" as
desired (see
Figure 34).
Note: Choose "Cut" mode for outline burns
through a workpiece, or "Scan" mode for fill
layers used in engraving.
7. Set "Min Power (%)" and "Max Power (%)" as
desired (see
Figure 34).
Note: On Models G0913 and G0914, set
"Min Power (%)" and "Max Power (%)" for
secondary laser tube next to #2 checkbox.
Tip: Test scrap workpiece material with
lower power settings (below 20%) and slowly
increase power to determine best setting for
workpiece material (see
Cutting/Engraving
Tips on Page 40 for more details). This set-
ting can be changed during operation on
Model G0911–G0914's control panel.
8. Select "Ok" at bottom of dialog box to return
to control panel.
— If saving to included USB flash drive, pro-
ceed to
Saving .RD File to USB Flash
Drive on Page 34.
— If saving directly to machine using USB
transfer cable, proceed to
Saving .RD File
to Machine w/USB Transfer Cable on
Page 34.
— If saving directly to machine using an
ethernet cable (not included), proceed to
Saving .RD File Using Ethernet Cable
on
Page 35.
Summary of Contents for G0911
Page 100: ......
