Model G0899 (Mfd. Since 10/20)
-75-
Miter Gauge
Adjustments
The miter gauge can be adjusted so it is perpen-
dicular to the blade and snug in the T-slot.
Tools Needed
Qty
90° Square ........................................................ 1
45° Square ........................................................ 1
Hex Wrench 2mm .............................................. 1
Hex Wrench 2.5mm ........................................... 1
Hex Wrench 4mm .............................................. 1
Checking/Setting 90° Stops
1. DISCONNECT MACHINE FROM POWER!
2. Slide miter gauge into T-slot on table.
3. Loosen miter gauge lock knob then pivot miter
gauge body to 90° position (see
Figure 132).
Figure 133. Checking 90° stop on miter gauge.
Square
Miter Gauge
Blade
— If square does not touch miter body and
blade body evenly at same time, then pro-
ceed to
Step 5.
— If square touches miter body and body of
blade (not the teeth) evenly at same time,
then it is square to blade and 90° stop is
set correctly. No further adjustments are
necessary.
5. Loosen lock nut on 90° set screw (see Figure
132), then adjust set screw until miter body is
flush with square. Tighten lock nut.
6. Adjust pointer by hand to point at 90°.
Figure 132. Screws for adjusting miter stops.
Lock Knob
Lock Nut
Set Screw
Adjusting Miter Bar Tightness
The miter bar can be adjusted so it fits more tightly
in the miter slot. To adjust the miter bar tightness,
adjust the set screws shown in
Figure 134 as
needed. Bar should slide with little resistance.
Figure 134. Set screws for adjusting miter bar
tightness in miter slot.
Set Screws
4. Place square evenly against face of miter
gauge and blade, as shown in
Figure 133.
Summary of Contents for G0899
Page 92: ......