-22-
Model G0899 (Mfd. Since 10/20)
1. Thoroughly clean heavy-duty rust preventa-
tive off of gearing inside the saw and coat
these with appropriate metal protectant (refer
to
Lubrication on Page 62 for location of
gears).
2. Slide groove on back of each handwheel over
handwheel shaft pin, as shown in
Figure 15.
To assemble table saw:
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Figure 18. Motor door installed.
Hinge
Socket
5. Remove switch from inside saw cabinet, and
install motor door by inserting door pins into
hinge sockets on cabinet (see
Figure 18).
4. Raise motor with blade height handwheel and
remove foam shipping block (see
Figure 17).
Save block for later machine transport
(if necessary).
Figure 17. Foam shipping block location.
Foam
Shipping Block
3. Thread handwheel lock knob into center of
each handwheel and tighten, then thread
handle onto each handwheel and tighten
(see
Figure 16).
Figure 16. Handwheel installed.
Handles
Lock
Knob
Figure 15. Handwheel installed on shaft pin.
Pin
Groove
Handwheel
Summary of Contents for G0899
Page 92: ......