Grizzly G0899, Owner'S Manual, Page: 67 / 92

Model G0899 (Mfd. Since 10/20)
-65-
Blade Tilt Stops
The table saw features stop collars that stop the
blade exactly at 45° and 90° when tilting it with
the handwheel.
The stops have been set at the
factory and should require no adjustments, unless
you notice that your cuts are not accurate.
Note: The tilt scale reads "0" when the blade is
90° to the table.
Tools Needed Qty
90
° Square ........................................................ 1
45° Square ........................................................ 1
Hex Wrench 2.5mm ........................................... 1
Hex Wrench 3mm .............................................. 1
Setting 90° Stop Collar
1. DISCONNECT MACHINE FROM POWER!
2. Raise blade as high as it will go, then tilt it
toward 0° until it stops and cannot be tilted
any more.
3. Place 90° square against table and blade so
it contacts blade evenly from bottom to top,
as shown in
Figure 112. Make sure blade
tooth does not obstruct placement of square.
— If blade is 90° to table, then adjustments
do not need to be made. Make sure
tilt indicator arrow shown in
Figure 113
points to 0° mark on scale. Adjust position
by loosening button head screw, moving
indicator with your fingers, then tightening
screw.
Figure 112. Checking blade at 90°.
Table
90° Square
Blade
— If blade is not 90° to table, you will need
to adjust 90° stop collar. Proceed to next
step.
4. Tilt blade away from 0° by about 5°, so there
is room for 90° stop collar to move.
5. Open motor door, loosen set screws shown
in
Figure 114, then thread 90° stop collar
one turn away from trunnion bracket. This will
allow you to square blade in next step.
6. Place square against blade, as shown in
Figure 112, then adjust blade until it is per-
fectly square to table.
7. Without turning blade tilt leadscrew, finger-
tighten 90° collar against trunnion bracket,
then tighten two set screws to secure collar
position.
8. Repeat Steps 2–3 to verify that collar adjust-
ment you made was correct. When adjust-
ment is satisfactory, close motor door.
Figure 114. 90° stop collar and set screws.
Trunnion
Bracket
Set Screws
90° Stop
Collar
Figure 113. Tilt indicator arrow.
Indicator