Grizzly G0849, Owner'S Manual

Page: 23 / 56

Model G0849 (Mfd. Since 01/19)
-21-
30. Loosen set screw inside brush spindle con-
nector, attach filter brush assembly to filter
cover plate using (2)
1
⁄
4
"-20 x
1
⁄
2
" flat head
screws and (2)
1
⁄
4
"-20 lock nuts (see Figure
27), then tighten set screw.
31. Place filter cover plate gasket on top of impel-
ler housing, then slide filter brush assembly
through top of impeller housing opening and
into canister filter.
Figure 28. Bottom of filter brush assembly
attached to canister filter.
32. Place mounting bar inside canister filter and
loosely attach bottom of filter brush assem-
bly to mounting bar using (2)
1
⁄
4
"-20 x 1" hex
bolts, (4)
1
⁄
4
" flat washers, and (2)
1
⁄
4
"-20 lock
nuts (see Figure 28).
33. Attach mounting bar to canister filter with (2)
1
⁄
4
"-20 x 1" knob bolts, then tighten hex bolts
and lock nuts to secure filter brush assembly
to mounting bar (see
Figure 28).
Filter
Brush
Assembly
Mounting
Bar
x 12
35. Attach filter brush motor to filter cover plate
(see Figure 30). Secure with (4)
1
⁄
4
"-20 x
3
⁄
4
"
hex bolts and (4)
1
⁄
4
" flat washers.
Note: When installing the motor, you may
need to have an assistant rotate the filter
brush assembly from below to help align
the brush shaft and motor spindle. After the
brush shaft and motor spindle engage, turn
the motor bracket until mounting holes align
with the filter cover plate.
34. Secure filter cover plate in a star pattern
using (12)
5
⁄
16
"-18 x
3
⁄
4
" hex bolts and (12)
5
⁄
16
"
fender washers (see
Figure 29).
Figure 29. Filter cover plate installed.
Filter
Cover
Plate
Figure 30. Filter brush motor attached to filter
cover plate.
Filter
Brush
Motor
x 4
x 12
Figure 27. Filter brush assembly attached to
filter cover plate.
x 2
Filter Brush
Assembly
Set Screw
36. Tighten (2) set screws on motor spindle (see
Figure 30).
Set
Screws