Grizzly G0849, Owner'S Manual

Page: 21 / 56

Model G0849 (Mfd. Since 01/19)
-19-
16. Final tighten all fasteners installed through
Step 15. Double-check that all are secure.
17. Remove lifting equipment.
18. Place gasket on intake cylinder flange (see
Figure 20, inset).
19. Attach intake cylinder to impeller housing
using (4)
5
⁄
16
"-18 x
3
⁄
4
" hex bolts and (4)
5
⁄
16
"
fender washers (see Figure 20).
21. Place gasket on intake barrel flange (see
Figure 22, inset).
22. Have assistant hold intake barrel and attach
to impeller housing using (12)
5
⁄
16
"-18 x 1"
hex bolts and (12)
5
⁄
16
" fender washers (see
Figure 22). Finger-tighten for now.
Note: Mount intake barrel with dust port
pointing out and away from front of impeller
housing.
23. Place gasket on cyclone funnel flange (see
Figure 23, inset).
24. While assistant aligns cyclone funnel so ver-
tical seam faces rear of machine, attach to
intake barrel using (12)
5
⁄
16
"-18 x 1" hex bolts,
(24)
5
⁄
16
" fender washers, and (12)
5
⁄
16
"-18 hex
nuts (see
Figure 23). Finger-tighten for now.
Figure 23. Cyclone funnel attached to intake
barrel.
Gasket
x 12
Cyclone
Funnel
Vertical
Seam
Figure 20. Intake cylinder installed.
Gasket
Intake Cylinder
x 4
Impeller
Housing
Figure 22. Intake barrel attached to impeller
housing.
Gasket
Intake Barrel
Dust Port
Impeller
Housing
x 12
1
2
3
4 5
6
Figure 21. Star-pattern fastener tightening
sequence.
20. Tighten bolts in a star pattern, as shown in
Figure 21.
Intake
Barrel
Cyclone
Funnel