Model G0819 (Mfd. Since 09/16)
-57-
Sanding Belt Limit
Switches
To adjust belt tracking limit switches:
1.
DISCONNECT MACHINE FROM POWER!
2
.
Make sure sanding belt tracking and oscilla-
tion is adjusted properly (refer to
Page 43).
3. Release belt tension, center sanding belt on
top roller, then re-tension belt.
4. Measure distance from edge of sanding belt
to ceramic rod protruding from switch.
5. Loosen adjustment bolt shown in Figure 93,
and move switch so belt and ceramic rod are
approximately
1
⁄
4
" apart.
6. Tighten bolt and repeat adjustment with other
side if necessary.
7. Start machine and make sure it is working
properly.
Sanding belt tracking limit switches are placed
on both sides of the belt to act as emergency
machine stops if the belt travels too far to one side
or the other during oscillation (see
Figure 93).
Tools Needed:
Qty
Open-End Wrench 12mm ...................................1
Figure 93. Tracking limit switch adjustment bolt
(right side shown).
Adjustment Bolt
Location
Summary of Contents for G0819
Page 84: ......
