-38-
Model G0819 (Mfd. Since 09/16)
Grease Fittings
Oil Type ............... T23964 or NLGI#2 Equivalent
Oil Amount ............1–2 Pumps from Grease Gun
Check/Add Frequency ............................. Weekly
Wipe the fittings clean with a rag. Attach a flexible
grease gun extension to a grease gun. Add one or
two pumps of grease to the grease fittings located
on the conveyor belt roller axles and the sanding
belt roller axles (see
Figures 54–55). They are
identified with yellow labels.
Table Elevation Leadscrews, Chain &
Sprockets
Oil Type ............... T23964 or NLGI#2 Equivalent
Oil Amount ............................................Thin Coat
Check/Add Frequency .............................Monthly
Lower table all the way, then remove the lower
left access panel. Use a shop rag and mineral
spirits to remove the old lubricant and built-up
grime from the leadscrews, chain, and sprockets
(see
Figure 56). Brush grease onto the lead-
screws, chain, and sprockets, being careful to not
get grease on the V-belts. This could cause the
V-belts to slip on the pulleys. If you do get grease
on the V-belts, replace them. Raise the table up
and down a few times to evenly distribute the
grease.
Figure 56. Location of table elevation
leadscrews, chain, and sprockets (lower left
access panel removed).
Chain
Sprockets
(1 of 4)
Leadscrews
(1 of 4)
Figure 54. Locations of upper left/right sanding
belt roller axle grease fittings.
Figure 55. Locations of conveyor belt roller axle
grease fittings (chain cover removed for access).
Summary of Contents for G0819
Page 84: ......
