-18-
Model G0819 (Mfd. Since 09/16)
Lifting & Placing
HEAVY LIFT!
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
Do not attempt to lift or move this machine without
using the proper lifting equipment (such as forklift
or crane) or the necessary assistance from other
people. Each piece of lifting equipment must be
rated for at least 1000 lbs. to support dynamic
loads that may be applied while lifting. Refer to
Needed for Setup on Page 14 for complete list
of needed equipment for setup and installation.
To lift and move machine:
1. Remove shipping crate top and sides, then
remove small components from shipping
pallet.
2. Move machine to its prepared location while
it is still attached to shipping pallet.
4. Use forklift (see Figure 18) to lift machine just
enough to clear pallet, then move pallet out of
the way, and gently lower machine onto floor.
Figure 18. Lifting machine with forklift.
Figure 17. Access panel removed to expose
mounting hardware (left side shown).
3. Open lower access panels, and remove
(4) lag screws and flat washers that secure
machine to pallet (see
Figure 17).
Note: The holes where these fasteners are
removed from will later be used to anchor
machine to floor.
x 4
Summary of Contents for G0819
Page 84: ......
